Chapter 3: Configuration Options
Unit Management Page
Click Admin > Unit Management to access the page shown in Figure 23. Options are described in Tabl e 14 .
FIG. 23
Unit Management Page
TABLE 14 Unit Management Option Descriptions
Option Description Notes
Auto Discover/Discover
Units button
If this button says Auto Discover, then N-Command is
scanning periodically for new units. If it says Discover
Units, click to search for newly-added units on the
network.
Discovery is
Enabled/Disabled
If this button says Discovery is Enabled then
N-Command can discover units on the network. Click to
change to Discovery is Disabled at which point
N-Command will no longer discover units on the
network.
Remove Selected Click to remove all selected units from the Unit
Management page display.
Removes the selected unit from the list of units
discovered by N-Command.
Remove All Offline Click to remove all inactive units from the Unit
Management page display.
Removes any units in the list that are offline/not
communicating.
Add by IP Click to search for and add a unit by its IP address.
Import CSV Click to select a CSV file to import for batch
configuration.
Export CSV Click to export the CSV file for editing.
Select All button Click to select all units in the list.
Select None button Click to clear out any selections.
Search field Search for a unit on the network by name, IP address,
stream, etc.
Anything listed in the column headings of this page
can be used as a search term (e.g., Name, Type, SN,
etc.).
To Next Page
Loading...
Need help?
General
