AMX SC-N8012 User Manual

Appendix C: Minimum Network Requirements
56
N-Command User Manual
A policer typically drops traffic.
Differentiated Services Code Point (DSCP) values can be configured in N-Series devices if QOS is required on the
network.
Shaping
A shaper typically delays excess traffic using a buffer, or queueing mechanism, to hold packets and shape the flow when
the data rate of the source is higher than expected.
Cannot be used with N2300 series.
7. TCN Flood Off
TCN (Topology Change Notification) flooding will cause unnecessary backplane and bandwidth usage when adding or
removing a device on the network, which can cause stream interruptions as the flooding sweeps through the network.
Note that this command has to be assigned individually per port that is assigned to that VLAN. However it is not
necessary with ports on the same switch that will not be set up on the same VLAN as the N-Series devices.
- Command Example: NO IP IGMP SNOOPING TCN FLOOD
Should you encounter any problems not covered by these guidelines, please contact technical support via email
(
svsisupport@harman.com) or call 256.461.7143 x9900.

AMX SC-N8012 Specifications

General

Brand	AMX
Model	SC-N8012
Category	Controller
Language	English