Preliminary Technical Data UG-1828
Rev. PrC | Page 299 of 338
Figure 278. Setup Revision Information
Configuring the Device
Contained within the Device Configuration tab are setup options for the device. In this page the user can select the following:
• Product:
• Supports ADRV9002, ADRV9003 and ADRV9004
• System
• TDD, FDD, TDM_FDD are supported
• Under TDD
• DMR setup is supported
• Analog FM setup is supported
• LTE setup is supported
• Configuration 1, 3 and 4 setup is supported
• Custom
• Custom Extended (allows the System Clock to run as slow as 150 MHz)
• Under FDD
• Analog FM setup is supported
• LTE setup is supported: This mode allows users to configure different channel configurations such as Rx2/Tx1.
• Configuration 2 setup is supported
• Custom
• Custom Extended (allows the System Clock to run as slow as 150 MHz)
• Under TDM_FDD
• Tetra is supported
• Custom configuration is supported
• Custom Extended (allows the System Clock to run as slow as 150 MHz)
• SSI can be set to CMOS or LVDS
• There is 1 or 4 lane options for CMOS
• 2 lanes for LVDS
• SSI Strobe can be set to long or short
• Signal type, this depends on the selected system and setup
• RX supports I/Q and frequency deviation types and bit lengths
To Next Page
Loading...
Need help?
General
