AND MPA-10 - Total Discharge Function; Pre-dispensing Function; Advanced Dispensing Jobs

To Next Page

To Previous Page

1 ) Setting the reverse mode

(The display is example.)

[ 1 ] Press the Back key.

[ 2 ] Press the Up or Down Key to select "SYS".

[ 3 ] Press the Enter key to enter the system

setting mode.

[ 4 ] Press the Enter key several times until

is displayed.

[ 5 ] Turn the blowout operation mode OFF

using the Up/Down key, then confirm this

selection by pressing the Enter key.

[ 6 ] Turn the reverse operation mode ON using

the Up/Down key, then confirm this selection

by pressing the Enter key.

[ 7 ] End the system setting mode by pressing the

Enter key while is being

displayed.