AND MPA-10 - Program Setting Mode; Reverse Operation

To Next Page

To Previous Page

[ 3 ] The pipette executes the set count of aspirating-

dispensing cycles while leaving approximately

1/3 of the set mixing volume in the tip.

[ 4 ] Press the Operation key on the pipette to

dispense the liquid remaining in the tip.

(When the blowout function is ON ( ).)

[ 5 ] One mixing operation is completed once the

aspirated liquid is completely discharged.

When the operation is completed a buzzer

sounds twice.

9-4 System setting mode（SYS）

The SYS mode is used to perform or read out pipetting operation settings that suit the

purpose or the liquid to be handled.

2) Operating the system setting mode

(The display is example.)

[ 1 ] Press the Back key.

Dispensing to absorption

Repeat with mixing count

set.