After you have removed the spectrograph from the box and checked all components against the packing list and they
are as ordered, please follow the instruction below to prepare your spectrograph for use. An overview of the main steps
is shown below:
1. Installing the software (Solis for Spectroscopy or SDK).
2. Connecting the power and USB cables to spectrograph and computer.
3. Attaching camera(s) to spectrograph output port(s) - if applicable.
4. Connecting the camera data and power interface, e.g. USB and power supply (some cameras may require a
PCI card. If this is applicable, refer to the relevant manual for instruction on how to install the PCI card into your
computer).
5. Turning the system on.
6. Installing the spectrograph and detector drivers.
Once these steps are completed, your spectrograph is ready for use.
To Next Page
Loading...