When the Andor Solis software is installed, the drivers for the Shamrock should be in the Shamrock USB Drivers folder.
This is shown in the example below:
NOTE: If the drivers are not present, copy the Shamrock USB Drivers folder from the installation CD-ROM to the
Andor Solis folder.
1. After the Power and USB cables have been plugged in as described in “Connecting the Power and USB
Cables” on page 25, switch the power on to the spectrograph.
2. The Found New Hardware Wizard appears.
NOTE: If this does not appear, rstly check that the USB cable is securely connected. If that is OK then
double-click on the “New unknown USB device” icon.
The found New Hardware Wizard will now appear.
3. When the dialog box is active, select the No, not this time option.
4. Click Next>.
5. Select the Install from a list or specic location (Advanced) option then click Next>.
6. Select the Don’t search. I will choose the driver to install option then click Next>.
7. Proceed through the remaining prompts.
8. Click Finish to complete the installation.
To Next Page
Loading...