Andor Technology Shamrock 500i - Page 64

65 pages

To Next Page

To Previous Page

Shamrock 500i & 750

Version 2.1 rev 13 Feb 2017

Screw Type Requirements

• CCD ange to spectrograph ange 4 off, M4 x 16

• Camera to CCD ange 4 off, M3 x 10

• iXon camera to iXon ange 4 off, M5 x 10, countersunk, hex head

Main Page

Table of Contents2
Section 1: Introduction10
Technical Support11
Disclaimer12
Copyright and Protective Notices12
Trademarks and Patent Information12
1.5 Packing List13
- Optional Accessories14
Accessories for the Shamrock Series14
Section 2: Product Overview15
External Features and Model Options15
- Shamrock 500I15
- Shamrock 75016
Signal and Power Connections (500I and 750 Models)17
- Front Panel17
- Rear Panel18
Power Supply19
Section 3: Installation20
An Overview for Setting up Your Shamrock Spectrograph20
- Removing the Flipper Mirror Locking Screws21
- Installing the Software (Solis Spectroscopy/Sdk)23
- Software and Driver Installation24
- Connecting the Power and USB Cables25
Attaching a Camera to the Shamrock26
- USB Camera Signal and Power Connections27
- Standalone Spectrograph28
- Pre-Aligned Camera and Spectrograph29
  - Attaching the Camera29
Installation of Filters (if Applicable)30
- Filter Access30
- Initializing the Filter Wheel31
- Filter Wheel Control and Updating the Filter Details Stored in the Spectrograph Memory31
Grating Turret Replacement32
Installation of Accessory Parts33
- Grating Adjustment34
  - Correcting for Yaw34
  - Correcting for Roll and Tilt35
Section 4: Operation36
Emergency Mains Disconnection37
Detector Controls37
- Exposure Time Control37
- Read Mode Control38
Spectrograph Controls39
- Reset Menu Options39
- Wavelength Drive Control40
  - Changing the Wavelength Range40
- Step and Glue41
  - Relative Efficiency Correction44
Grating Turret Control45
Offset Adjustment Control46
- Manual Grating Offset Adjustment Procedure47
Slit Drive Control48
Filter Wheel Control49
Shutter Control50
- Control of Shutter Via External TTL Signal51
  - External Control of the Shutter51
Flipper Mirror Control52
Dispersion Optimiser53
- How to Use the Dispersion Optimiser54
Section 5: Maintenance57
5.1 Regular Checks57
5.2 Annual Electrical Safety Checks57
5.3 Fuse Replacement57
Cleaning (External)57
Section 6: Troubleshooting58
Section 7: Specifications59
Specifications (Electrical and Environmental)59
Specifications (Optical)60
Appendix A: Mechanical Drawings61
Appendix B: Other Information65

Related product manuals

Andor Technology Mechelle

65 pages

Andor Technology Shamrock 500i - Page 64

Table of Contents

Related product manuals