User’s Manual for Node M and Node C
Network Elements
Page 24 M0121A4A.doc
4.1.2. Wall Mounting Procedure
Check the wall mounting kit and the wall to determine their suitability.
Mark the position of the drilling holes - four per unit - for the Node according to
figure 4-1. Please observe that the figure always shows a pair of drill holes for
each position. Only drill one of each pair.
figure 4-1 Positions of drilling holes
) Note: Ensure that there is free access to the electrical connections as well
as to the cabinet. The approved bending radius of the connected
cables must not be exceeded.
To Next Page
Loading...
