Page 5
FIGURES AND TABLES
figure 3-1 Ethernet connector RJ45 19
figure 3-2 Pin connection 20
figure 3-3 Cable gland position 20
figure 4-1 Positions of drilling holes 24
figure 4-2 Wall mounting procedure 25
figure 4-3 Pole mounted units 26
figure 4-4 Back-to-back pole mounting 27
figure 4-5 Grounding bolt 30
figure 4-6 Power supply plug 31
figure 4-7 Mains connector of a Node M, exemplary 31
figure 4-8 Mains connector and antenna connections of a Node C, exemplary 31
figure 4-9 Front view of antenna connections from Node C, exemplary 33
figure 4-10 Front and top cover screws 34
figure 4-11 Position of mains power switch 35
figure 5-1 Configuration of a network element 37
figure 5-2 RF path of a Node C 843, exemplary 38
figure 5-3 Node M/C x37 MCPA DL final amplifier 42
figure 5-4 Node M 2143 and Node M 1943 MCPA DL final amplifier 42
figure 5-5 Node M/C 843 DL final amplifier 43
figure 5-6 Power supply, Node M/C x37 44
figure 5-7 Power supply, Node M/C x43 44
figure 5-8 Modem MC35 45
figure 5-9 Redwing modem (CDMA) 45
figure 5-10 Modem AnyDATA iPORT EMIII Dual / EM IV Dual 46
figure 5-11 Modem Raven XT 46
figure 5-12 Modem MTCBA-C-N9 46
figure 5-13 Cable from modem to donor duplexer 47
figure 5-14 Cable from modem to external modem antenna port; Node M 47
figure 5-15 Digital channel module, DL part 48
figure 5-16 Digital channel module, UL part 48
figure 5-17 EAC-board, installed 49
figure 5-18 Function of LEDs on the EAC-board 51
figure 5-19 Pin assignment 52
To Next Page
Loading...
Need help?
General
