ES
FR
DE
GB
IT
C13148123_GB.fIDM
English
-
51
-
Use and installation manual
OPE
Oven door opening or closure
request
Open or close the oven door
Inform the after-sales service if
this message continues to be
displayed
The cooking cycle does not start
until the door has been opened
or closed as required
CLE
Indicates that cleaning is re -
quired
Launch an automatic cleaning
cycle
The oven's functions are ena-
bled so cooking cycles can be
carried out
E01
The cooking chamber probe
has failed or is not properly con-
nected
Inform the after-sales service
The oven's functions are disa-
bled so no cooking cycles can
be carried out
E02
The core probe has a failure or
has not been properly connected
Check the position of the prod-
uct core probe or inform the af-
ter-sales service if it is faulty
Cooking cycles with p roduct
core probe cannot be carried
out
E03
The steam discharge probe has
failed
Inform the after-sales service
Convection and steam cooking
cycles can still be carried out
E04
The motor-operated valve is not
positioned correctly
Switch on the oven again and if
the problem persists inform the
after-sales service
Convection and steam cooking
cycles can still be carried out
E05 Safety thermostat failure Inform the after-sales service
The oven's functions are disa-
bled so no cooking cycles can
be carried out
E06 Overload cutouts tripped Inform the after-sales service
The oven's functions are disa-
bled so no cooking cycles can
be carried out
E07 Power board failure Inform the after-sales service
The oven's functions are disa-
bled so no cooking cycles can
be carried out
E08
The optional vacuum probe has
failed or is not properly connect-
ed
Press the "Reset" button
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle.
If the problem persis ts, call the
after-sales service
E10
Electrical component compart-
ment has overheated
The oven solves the problem on
its own
The oven's functions are ena-
bled so cooking cycles can be
carried out
E11
E13
E14
Electronic circuit board diag-
nostics tripped
Inform the after-sales service
The oven's functions are disa-
bled so no cooking cycles can
be carried out
E19
The humidity probe has failed or
is not properly connected
Inform the after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
E20 Setup error Inform the after-sales service
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Alarm Fau lt Remedy Notes
To Next Page
Loading...
Need help?
General