ES
FR
DE
GB
IT
C13148123_GB.fIDM
English
-
60
-
Use and installation manual
To carry out this o peration, pro-
ceed as follows.
1–Undo the screws to remove the
side panel (A).
2–Open the fuse-holder (B) and
replace the damaged fuse (C).
3–Replace the fuse-holder and
the side panel when the operation
is complete.
REPLACING THE FUSE
To carry out this o peration, pro-
ceed as follows.
1–Undo the screws and remove
the lamp cover (A).
2–Extract and replace the
lamp (B).
During the procedure, take care
not to touch the lamp directly;
wear protective gloves if neces-
sary.
3–Replace the lamp cover (A)
and retighten the screws when the
operation is complete.
CHANGING THE LAMP
When decommissioning the appliance, a series of procedures must be carried out to
ensure that the appliance and its components are not a hindrance and are not easily
accessible.
To ensure that the appliance cannot constitute hazards for people or the environment,
all energy sources (electricity, etc.) must be disconnected and rendered unusable, and
any liquids present must be drained (lubricants, fluids, etc.).
Place the appliance in a suitable area which is not easily accessible, with barriers to
prevent anyone from accessing it.
When scrapping, sort all components by chemical characteristics and dispose of them
separately in accordance with the relevant legal requirements.
This operation must be carried out by skilled operatives in compliance with the
legal requirements with regard to safety at work. Never dump non-biodegrada-
ble materials, lubricating oils and non-metallic components (rubber, PVC, res-
ins, etc.) in the environment. Dispose of them in accordance with the relevant
legal requirements.
DECOMMISSIONING THE APPLIANCE
To Next Page
Loading...
Need help?
General