Page 10 of 23
Important: If the over-temperature device activates and turns the
motor off, and you do not switch off and unplug the appliance from
the power point, the motor will restart automatically after it has
cooled down enough to reset the safety device.
This could cause damage to your floor surface as the brush bar
will start spinning in the one spot.
NOTE: NEVER BLOCK ANY VENTS OR OPENINGS AND
KEEP FILTERS CLEAN.
9 Power On / Off Switch
The Motor On / Off switch.is located in the floor head.
To turn the motor on, using your foot, press and release the On /
Off Switch.
Press the On / Off switch again to turn it off.
To Next Page
