EasyManua.ls Logo

anko VC-9790 - Pre-Motor Filter

anko VC-9790
23 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Page 19 of 23
Close the Dust Canister lid ensuring it clips shut, then refit the dust
canister to the vacuum cleaner.
It is recommended to replace the filter every 3 6 months, or sooner
if required.
14.1.2 Pre-Motor Filter
The pre-motor filter is located in the bottom section of the vacuum cleaner
where the dust canister locates.
Rotate the cover anticlockwise and lift straight off exposing the filter.
Refer
to the text moulded into the cover.
Grasp the Filter tightly and whilst rotating it, pull it straight up and out.
The filter is a tight fit so as to create a proper seal, so may require a little
force to remove it.
Note: Only wash the filter if it is very dirty, otherwise just tap the edge of
the filter on a hard surface to dislodge any dust and remove any large
debris.

Related product manuals