Page 11 of 23
10 Floor Head Release
To Lower the Handle, place your foot on the top of the floor head,
to hold it firmly on the floor, and then pull the vacuum cleaner
handle back.
The floor head latching mechanism will release and you are now
ready to start vacuuming the floor.
Note: when the latching mechanism releases, it will make a “click”
noise. This is no reason for alarm as it is just the latching
mechanism operating.
NOTE: When the handle is lifted back up to the park position, the
Floor Head Rotary Brush will still continue to rotate.
The floor head will lift up slightly, however, it is strongly
recommended that you do not allow the Vacuum Cleaner to sit
on one spot while the Brush Bar is rotating as this may cause
damage to the flooring surface.
To Next Page
