Page 9 of 23
7 Floor Head Height Adjustment
The floor head is adjustable in height to suit low to high-pile
carpets and for hard floors.
• Turn to position “0” for Low pile carpet.
• Turn to position “1” for Hard floors.
• Turn to position “2 or 3” for carpet between Low Pile and
Medium pile carpet.
• Turn to position “4” for High Pile Carpet.
Note: you can fine-tune the height in-between these Major
settings to suit your carpet.
8 Safety Devices Operation
NOTE: The motor has an overheating protection device built in.
It will automatically switch off the power to the motor if it
overheats. e.g., from blocked nozzles, a full dust canister or
uncleaned blocked filters.
If this happens, switch off the vacuum and unplug it from the
power point, clean blockage and / or filters and allow it to rest for
at least 60 minutes which should be enough time for the motor to
cool down.
To Next Page
Loading...
