Page 7 of 23
5 Assembly Method
Please Note: Always switch off and remove the plug from the
power point before fitting or removing accessories, including the
dust canister.
Ensure all Filters are fitted and fitted correctly before using.
5.1 Fitting / Removing the Handle
To fit the handle, place the end of the tube into the hole in the
top of the vacuum cleaner.
The Handle Release Lever may need to be pushed down to let
the tube in.
Once the tube is in the hole, release the lever then push down
hard until the tube locks in place.
To remove the handle, press the Handle Release Lever down
and whilst holding it down, grasp the handle and pull it straight
up and out.
To Next Page
Loading...
