A-3 Alphabetical Listing
A-14 PN: 10370-10374 Rev. F MG369xC GPIB PM
UL1 Enables RF unleveled SRQ generation. 3-120
UP Increments the open parameter by the step size. 3-120
US Microsecond (s) data terminator. 3-120
VM1 Turns on the video marker mode. 3-121
VT Volts data terminator. 3-121
W1 Opens the internal pulse width 1 parameter. 3-121
W2 Opens the internal pulse width 2 parameter. 3-121
W3 Opens the internal pulse width 3 parameter. 3-122
W4 Opens the internal pulse width 4 parameter. 3-122
XL0 Opens the L0 parameter. 3-123
XL1 Opens the L1 parameter. 3-123
XL2 Opens the L2 parameter. 3-123
XL3 Opens the L3 parameter. 3-124
XL4 Opens the L4 parameter. 3-124
XL5 Opens the L5 parameter. 3-124
XL6 Opens the L6 parameter. 3-125
XL7 Opens the L7 parameter. 3-125
XL8 Opens the L8 parameter. 3-125
XL9 Opens the L9 parameter. 3-126
XP Turns on the external pulse modulation function. Disables the
internal pulse modulation function, if previously programmed.
3-126
Y Equivalent to a Group Execute Trigger (GET). 3-126
ZEL Ends frequency loading. 3-126
ZL(x) Loads a CW frequency into a table at location x. 3-127
ZPN(bbbb) Sets the table pointer to point to location bbbb. 3-127
ZS(x) Sets the table pointer to point to location x. 3-127
ZTL (bbbbnnnnD8D8D8…D8) Loads the frequency table starting at location bbbb. 3-126
Table A-1. Alphabetical GPIB Command List (13 of 13)
Command Code Function Page
To Next Page
Loading...
Need help?
General
