Anritsu ML248 A Series - Selecting the Measurement Display Style

ML248xA / ML249xA Common Procedures
5-16 13000-00162
September 2005
Selecting the Measurement Display Style
1. Press the Channel hard key to display the Channel group of commands.
2. Press the Set Up soft key to display the [Channel Set Up] dialog for the channel that
is currently active.
3. Press the down arrow on the numeric keypad to select the “Meas Display” item.
4. Use the soft keys to select the required mode. There are two options available;
“Profile” or “Readout”, the difference between which is explained earlier in this
chapter.
5. Use the down arrow on the numerical keypad to select another item in the dialog, or
press the [Exit] hard key if no further settings are required.
Note: The “Meas display” item is not available in CW mode.