Anritsu ML248 A Series - Linking the Channel Trigger Settings

Common Procedures ML248xA / ML249xA
13000-00162 5-37
September 2005
Linking the Channel Trigger Settings
The trigger settings for channel 1 and channel 2 can be linked in the manner described
below. The channels can only be linked when the “Mode” setting in the [Channel Set Up]
dialog is the same for both channels.
1. Press the Channel hard key to display the [Channel] group of commands.
2. Press the Trigger soft key to display the [Trigger] menu and then press More
followed by Link soft key. When the key is pressed, the trigger settings for the
active channel are copied to the inactive channel, and further changes are
automatically copied over thereafter.