Anritsu MS9710C User Manual

Remote Control
Read this manual before using the equipment. Keep this manual with the equipment.
Optical Spectrum Analyzer
Operation Manual
MS9710C

Anritsu MS9710C Specifications

General

Frequency Range	600 to 1750 nm
Wavelength Range	600 to 1750 nm
Display	5.7-inch color LCD
Interfaces	GPIB, USB, Ethernet
Input Power	+20 dBm
Battery Life	N/A (AC power only)

Summary

Section 1 Introduction

1.2 MS9710C Remove Control Functions

Lists functions controllable remotely, including most operations except power and local key.

1.3 Interface Port Application Selection Function

Section 2 How to Connect

2.1 Connecting Devices Using GPIB Cables

Details the physical connection of devices using GPIB cables, including specifications.

2.2 Connecting a Device Using an RS-232C Cable

Explains RS-232C connections, including connector types and cable configurations.

Section 3 Standards

3.1 GPIB Standard

3.2 RS-232C Standard

3.3 Device Message List

Classifies device messages into program and response messages, explaining their types.

Section 4 Initial Setting

4.1 Initialization of Bus by IFC Statement

Describes bus initialization using the IFC statement for GPIB interface functions.

4.2 Initialization of Message Exchange by DCL and SDC Bus Commands

Explains initializing message exchange using DCL and SDC commands.

4.3 Initialization of Devices by *RST Command

Details how the *RST command resets devices to a known state.

Section 5 Listner Input Formats

Section 6 Talker Output Format

Section 7 Common Commands

7.1 Classification of MS9710C-Supported Common Commands by Group Function

Classifies supported IEEE 488.2 common commands by their functional groups.

7.2 Classification of Supported Commands and References

Section 8 Status Structure

8.1 IEEE 488.2 Standard Status Model

Explains the standard status data structure defined by IEEE 488.2.

8.2 Status Byte (STB) Register

Details the STB register, including ESB and MAV summary messages.

8.3 Enabling the SRQ

8.4 Standard Event Status Register

Section 9 Details on Device Messages

9.1 ALIN [Auto Alignment]

9.2 ANA [Analysis]

9.4 AP [Application]

Section 10 Program Examples

10.1 Precautions on Creating a Program

Provides essential precautions for creating remote control programs.

10.2 Program Examples

Presents practical examples of programs for obtaining measurement data and analyzing waveforms.

Section 11 LabVIEW Measuring Instrument

11.1 Installation

11.3 List of Measuring Instrument Drivers

Appendix A Error Messages

A.1 System Errors (000 to 099)

A.2 Measurement Errors (100 to 199)