11-1
LabVIEW Measuring Instrument
11
This section explains the measuring instrument drivers (MX971003G/S) used to
control the MS9710C remotely under LabVIEW.
LabVIEW measuring instrument drivers are modules in which command send
and receive functions are incorporated, allowing measuring instruments to be
controlled under the U.S. National Instruments Graphic Programming System
“LabVIEW.” Using these drivers, you can control the MS9710C remotely with-
out remembering control commands.
To use this measuring instrument, a controller in which National Instruments
LabVIEW software (Windows version) is installed is required.
The measuring instrument drivers have been created using LabVIEW Ver. 4.0/J
(Windows version).
For how to use LabVIEW, see the LabBIEW User’s Guide.
About LabVIEW ...................................................... 11-2
11.1 Installation ..................................................... 11-2
11.2 Program Examples ........................................ 11-3
11.3 List of Measuring Instrument Drivers ............. 11-5
11.4 Description of Measuring Instrument Driver
Functions ....................................................... 11-9
11.4.1 Common parameters.......................... 11-9
11.4.2 Description of functions ...................... 11-10
Section 11 LabVIEW Measuring Instrument
LabVIEW is a trademark of U.S. National Instruments Corporation.
Windows is a trademark of U.S. Microsoft Corporation.
To Next Page
Loading...
Need help?
General
