Anritsu MS9710C User Manual

Appendix
A-2
A.1 System Errors (000 to 099)
000
001
002
003
004
005
006
007
008
009
010
No. Status
No error
Optical Error (RAM)
Optical Error (Slit-1)
Optical Error (Slit-2)
Optical Error (Wl Align)
Optical Error (Opt Att)
Not used
Optical Error (Light Source)
Optical Error (Grating)
Optical Error (Offset)
Optical Error (Over Power)
Error message
RAM error
Slit 1 error
Slit 2 error
Wavelength alignment error
Optical ATT error
Light source error
Grating error
Offset error
Excessive light input error
Output condition
A.2 Measurement Errors (100 to 199)
100
101
102
103
104
105
to
109
110
111
112
113
114
115
No.
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
ESE-DDE
Status
Auto Measure Incomplete
Can’t Find Peak
Can’t Find Dip
Not used
TMkr Not Display
Not used
Wl Cal Error (Optical Level)
Wl Cal Error
Align Error (Optical Level)
Align Error
Res Cal Error
TLS Calibration Error
Error message
Auto measurement has not been
completed normally.
No peak was found.
No dip was found.
No trace marker is displayed.
Insufficient optical level during
wavelength calibration
Wavelength calibration error
Insufficient optical level during
optical axis automatic alignment
Optical axis automatic alignment error
Resolution calibration error
Error on calibration with TLS
Output condition

Anritsu MS9710C Specifications

General

Brand	Anritsu
Model	MS9710C
Category	Measuring Instruments
Language	English