Section 9 Details on Device Messages
9-50
9.56 MKV [Marker Value Wavelength/Frequency Select]
■ Function
Converts the trace marker, the delta marker and wavelength values obtained from
a part of the analysis into frequencies and then displays them.
Header Program Query Response
MKV MKV s MKV ? s
■ Value of s
s = WL: Wavelength
= FREQ:Frequency
■ Initial setting value
s is a backed up value.
■ Default
s = WL
9.57 MOD [Measure Mode]
■ Function
Outputs a number indicating a measurement mode.
Header Program Query Response
MOD None MOD ? n
■ Value of n
n is output with a number, 0 to 3, indicating the following:
0: A spectrum is not being measured.
1: A spectrum is being measured (single sweep).
2: A spectrum is being measured (repeat sweep).
3: Power monitor
To Next Page
Loading...
Need help?
General
