Anritsu MS9710C - Response Message; Response Message Unit; Separator

Section 6 Talker Output Format
6-6
6.2.3 <RESPONSE MESSAGE>
<RESPONSE MESSAGE> is defined as follows:
<RESPONSE
MESSAGE UNIT
SEPARATOR>
Refer to 6.2.4
<RESPONSE MESSAGE UNIT>
Refer to 6.2.5
<RESPONSE MESSAGE> is a sequence of one or more <RESPONSE MESSAGE UNIT> elements.
The <RESPONSE MESSAGE UNIT> element is a single message sent from a device to a controller. A <RE-
SPONSE MESSAGE UNIT SEPARATOR> is used as a separator for separating multiple <RESPONSE MES-
SAGE UNIT> elements.
<Example> Adding CNF to the center frequency, adding SPF to the response data, and transfer-
ring them using a 1-character fixed format
CNF 123ØØØØØØ ; SPF 1ØØØØØØ
<RESPONSE MESSAGE>
<RESPONSE MESSAGE UNIT> <RESPONSE MESSAGE UNIT><RESPONSE MESSAGE UNIT SEPARATOR>
6.2.4 <RESPONSE MESSAGE UNIT SEPARATOR>
<RESPONSE MESSAGE UNIT SEPARATOR> is defined as follows:
;
<RESPONSE MESSAGE UNIT SEPARATOR> is used to separate <RESPONSE MESSAGE UNIT> elements
with a <UNIT SEPARATOR> (semicolon ( ; )) when outputting a sequence of multiple <RESPONSE MESSAGE
UNIT> elements as one <RESPONSE MESSAGE>.