UNION SWITCH & SIGNAL Microlok II System Startup, Troubleshooting, and Maintenance
4-4 September 2000 SM-6800C Rev. 2.5
4.2 INSTALLATION
The MICROLOK II Maintenance Tool is available on a 3.5” floppy disk that must be installed
onto your computer.
To begin the installation program, place the disk in an appropriate drive. Press the Start button,
and then click on Run.
If you place the disk in drive A:, enter the command: “A:\setup” in the Open: line of the Run
window. Then, press the OK button.
Continue to follow the directions provided on your computer’s screen by the installation
program. You will be asked to confirm or change the directory where the Maintenance Tool will
be installed. We recommend you accept the default directory: C:\Program Files\US&S\MLK2.
After the installation is completed you may choose to place a shortcut icon on your desktop. This
is done by right-clicking your mouse while pointing to a blank area of the desktop. From the
menu that appears, select New and then Shortcut. Press the Browse button, and use the file
dialog box to locate MICROLOK.EXE from the directory selected during installation.
After selecting the MICROLOK.EXE file, complete setting up the shortcut by pressing the Next
button. On the window that follows you may select a name for the shortcut icon, and then press
the Finish button.
To Next Page
Loading...
Need help?
General