Programming Getting Started
66 IQ-301 PN 50036:F 10/29/2001
3.2 Getting Started
3.2.1 How to Access Programming Options
To enter Program Change mode or Status Change mode, follow these steps:
1. Press the
ENTER
key to enter programming mode and the LCD display shows the
Programming Entry screen:
Figure 48 Programming Entry Screen
2. Press the 1 key and the following screen appears in the LCD display:
Figure 49 Password Entry Screen
3. Enter the Program Change or Status Change password.
3.2.2 Programming Passwords
There are two programming passwords: Program Change and Status Change:
• Program Change password – The password used to access Program Change
functions. The Program Change factory-set password is 00000.
• Status Change password – The password used to access Status Change functions.
The Status Change factory-set password is 11111.
Passwords are user-definable (refer to “How to Change a Programming Password
(3=passwd)” on page 85). If you enter an invalid password (or press the
ENTER
key
without entering a password), the LCD display shows the Incorrect Password screen,
like the one shown in Figure 50:
Figure 50 Sample Incorrect Password Screen
From the Incorrect Password screen (Figure 50), press the
BACKSPACE
key and enter the
correct Program Change or Status Change password or contact the manufacturer for
assistance.
1=PROGRAMMING
2=READ@STATUS@ENTRY
(BACKSPACE@TO@ABORT)
ENTER@PROG@OR@STATUS
PASSWORD,@THEN@ENTER.
(BACKSPACE@TO@ABORT)
INCORRECT PASSWORD
PROGRAM: 0000000
STATUS: 0880880
BACKSPACE@TO@ABORT
To Next Page
Loading...
Need help?
General
