ANTEK ECE10CM Series - User Manual

Questions and Answers

R
Richard WallerAug 4, 2025
What to do if my ANTEK Controller shows a TEMP error?
- M
  Mary WilliamsAug 4, 2025
  The TEMP error on your ANTEK Controller can be triggered by several factors: * Heat sink overheating: Allow the module or ballast resistor to cool down, reduce maximum current, or clean the heat sink and fan. * Motor protection contact triggered: Allow the module to cool down, reduce maximum current, adjust the IxR trimmer with EMF control, or clean the heat sink and fan. * Ballast resistor protection contact triggered: Allow the ballast resistor to cool down, avoid frequent or heavy braking, try a different size of ballast resistor, or use a mains module capable of energy recovery.
J
Joseph IrwinAug 13, 2025
What causes a LIMIT error on my ANTEK ECE10CM Controller and how do I fix it?
- M
  Mackenzie RichardsonAug 13, 2025
  The LIMIT error on your ANTEK Controller can be caused by several issues: * Speed regulator at modulation limit: Extend ramps, check the current limiter, motor, and wiring. Also, check the motor supply line and mains voltage if the intermediate circuit voltage is too low. * Drive control oscillating: Adjust control performance to the application. * Motor running untrue or not starting: Link up reference mass for analogue and digital inputs, ensure proper screening of inputs and motor cable earthing, and check commutation and motor phases. * Motor racing: Check commutation and motor phases.
W
wballAug 25, 2025
How to troubleshoot S-FAIL error on ANTEK Controller?
- S
  Sarah RuizAug 25, 2025
  If your ANTEK Controller shows an S-FAIL error, it indicates a fault in the feedback system. Check the sensors and wiring to resolve this issue.