Technical Documentation ECE10CM, DC10CM Page 7 of 39
1.3.2 Recommended Utilisation
♦ The Series ECE10CM & DC10CM converters are electrical operating equipment for use in
power plants.
♦ The Series ECE10CM & DC10CM converters are electronic drive controls for the control
and regulation of variable-speed
- permanently excited three-phase synchronous motors
- permanently excited DC motors
♦ The drive regulator ECE10CM und DC10CM are electrical devices for use in industrial
systems. The drive is intended for installation in switching cupboards or cabinets for drive
systems. Voltage-converters meet the EG safety standards for low-voltage.
♦ Drive systems incorporating the regulator ECE10CM resp. DC10CM, comply with EG-
standards for EMI when installed per the directives for CE-typical drive systems.
♦ The CE-typical drive systems with these voltage changers are intended for
– operation on public and non-public networks.
– use in the industrial area as well as in residential and business areas.
♦ CE-typical drive systems are not compatible with IT-networks (networks without reference
to earth-ground) due to the earth-ground reference of the radio-interference filter.
♦ The converters may not be operated on networks with a grounded phase.
♦ The converters are not household devices, they are intended for the construction of drive
systems for commercial use.
♦ The converters are not machines according to the EG-directives for machines.
The converter is only to be operated under the operating conditions stated in this operation
manual. Before installing the device, read this manual from beginning to end and .
follow the directions stated herein:
Store this manual near the converter for future reference.
1.3.3 Disclaimer
Liability
The information, data and instructions stated in this operating manual were up-to-date as of
the date of print. No claims can be made against previously delivered converters based upon
statements, illustrations/photos or descriptions contained in this operating manual.
The process-specific instructions and circuit extracts contained in this manual are
recommendations. Their applicability for the task at hand must first be verified.
The firm ANTEK – Antriebstechnik GmbH assumes no liability for the suitability of the
described processes and circuit suggestions contained herein.
No liability will be assumed for damages or malfunctions caused by:
♦ disregard of this operating manual
♦ unauthorized modifications made to the converter
♦ operator errors
♦ improper working on and with the converter
To Next Page
Loading...
Need help?
General