Name: ANTEK ECE10CM Series
Brand: ANTEK
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Page 28 of 39 Technical Documentation ECE10CM, DC10CM

n-max Maximum speed setting

1. Rough adjustment via S1-1, S1-2 &. R161

(See Chapter 5.4)

2. Specify maximum set point voltage (10V).

3. Set max. required speed on "n-max“ trimmer

(See sketch for trimmer OFFSET).

4. Check at "n-ACT“ test jack.

I-max Equipment peak current setting

External current default "I-LIMIT (X5-7)“ at analogue input

Apply potential ≥ 10 V. Set required peak current at I-max. trimmer

Check at "I-max“ test jack.

Questions and Answers:

Need help?

Do you have a question about the ANTEK ECE10CM Series and is the answer not in the manual?

ANTEK ECE10CM Series Specifications

General