EasyManua.ls Logo

Antelope Orion Studio - Connectivity; Technical Specifications

Antelope Orion Studio
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26.09.18, 10*54Antelope Audio : Customer Support
Seite 17 von 24https://support.antelopeaudio.com/support/solutions/articles/42000017660-orion-studio-rev-2017-user-manual
Connectivity:
If you believe there is no sound being received to an input or delivered from an output:
●● Check your source. Is there a signal being transmitted form the source?
●● Is your source in the correct sample rate for the Orion Studio to receive?
●● Check what clocking mode you are in. Are you receiving the clock signal from the source?
●● Check that the relevant lock light on the control panel of the Orion Studio is lit up.
●● Try a dierent cable and another source if available.
●● Check the routing on the control panel. Have you routed the signal path correctly?
●● If you have routed signals to the routing mixer, check their corresponding fader is up.
●● Check the relevant peak meters of the control panel by selecting them in the drop down
menu to see if the relevant signal is being received or is being outputted.
DAW
●● What buer size is your DAW set to?
●● If it is significantly low i.e. lower than 128 samples in your buer size, try increasing it. Try
increasing the buer size from the Orion Studio control panel (Windows Only)
●● Have you checked the input and output routing is correct in your DAW?
●● Is the Orion Studio device selected in the relevant sound card section of the DAW’s
preferences?
If the Orion Studio doesn’t show up in you DAW, first try unplugging and plugging back
the ThunderboltTM cable (or the USB cable), then restarting your Computer and finally
re-install the firmware, drivers and control panel for the Orion Studio.
11. Technical Specifications
Analog Inputs 4 x Mic / Line Instrument on XLR combos on the front
8 x Mic / Line on XLR combos on the rear
Analog Inserts 2 x Inserts on TRS (inputs 1,2)
Digital Inputs 2 x ADAT (up to 16)
1 x S/PDIF
Word Clock Input 1 x Input @ 75 Ohms 3Vpp on BNC 32 - 192kHz
Analog Outputs 16 x Lines on 2 x DB25 (16 channels)
2 x Stereo Monitor out on TRS (4 channels, only 1 active at a time)
2 x Stereo Headphone outs on TRS (4 channels)
2 x ReAmp outs on TRS (2 channels)
Digital Outputs 2 x ADAT
1 x S/PDIF
USB I/O 2.0 Hi-Speed; Data stream up to 480 Mbits/192kHz,
24 channels I/O, Type B
ThunderboltTM I/O 1 x ThunderboltTM, 32 channels I/O
Word Clock Output 1 x Outputs @ 75 Ohms 3Vpp on BNC 32 - 192kHz
D/A Monitor Converter
Dynamic Range: 129 dB
THD + N: -108 dB
D/A Converter
Dynamic Range: 120 dB
THD + N: -107 dB
A/D Converter
Dynamic Range: 124 dB
THD + N: -112 dB

Related product manuals