Large stepped attenuator for the volume of Monitor, Headphone, Line and Reamp
outputs. Clicking-in the large volume control allows you to scroll between the different
options.
5. Gain, HP & A/B
By clicking on those 3 buttons you can control the Orion Studio the following ways:
Gain takes you to the gain section so you can apply the required gain to any of the 12
pre amp inputs from the rotary encoder
HP cycles thru the two Headphone outpus so you can adjust the volume level from the
rotary encoder.
A/B cycles thru the 2 monitor outputs that can be adjusted from the rotary controller
6. Display
Multi-function display that displays various information when used from the 3 functional
buttons below.
Note: Be aware that there might be a protective film over the display, which dims the
illumination – feel free to remove it.
7. Functional buttons
By pressing the top and middle Function buttons you can cycle thru the display and view
various information
Βy holding down the Top Function button you can access the System Menu of the
device, which allows you to access the following sub-menus and confirm them by
pressing the rotary control:
1. Comm. Interface (allows you to choose between ThunderboltTM and USB connectivity)
2. Device Info : Displays the serial number of the device, the hardware revision and the
firmware version
3. Scr Save Time : Sets the time that the screen saver will appear on the Orion Studio
display.
4. Scr Save Style: Changes the style of the screen saver.
5. Talk Back HP1 : Sets weather the talk back mic will be outputted by the Headphones
1 output.
6. Talk Back HP2 : Sets weather the talk back mic will be outputted by the Headphones
1 output.
7. Talk Back MON : Sets weather the talk back mic will be outputted by the monitor outs.
8. Factory Reset: Performs a factory reset on the unit. Please note that by doing so all
presets, mixer and fx settings will be lost.
To scroll up and down, use the Rotary Control.
To enter each one of the sub-menus, press the Rotary Control.
To confirm a chosen setting, press and hold the Rotary Control.
Hold down the second Function button to access the Control Menu of the device, which
allows you to adjust:
1. Clock Source: Sets the clocking source for the Orion Studio
2. Sample Rate: Changes the sample rate of the Orion Studio
3. SR Conversion: Sets weather or not the the S/PDIF input is sample rate converted to
match the sample rate of the Orion Studio internal clock (eg. If you want the clock to run
at 192 kHz and your S/PDIF input is at 44.1 kHz, simply press this button to match the
sample rate frequency of the Orion Studio internal clock).
4. Peak Meter: Selects what is being displayed on the Meter screen of the Orion Studio
5. Monitor Trim: Sets the trim levels for the monitor outs
6. Line Out Trim: Sets the trim levels for the line outs
To Next Page
Loading...
