Setting operation in single image or multiple image mode (LCD
Touch DISPLAY only).
• With the camera set to LIVE mode, briefly press the button (A) to change
from viewing a single image to multiple images (and vice versa).
A dedicated icon, found in the top right-hand corner, signals on
the monitor when single-image mode is active.
Operation in single image mode.
• The "live" image appears on the monitor and a special icon (1) is shown
in the top right-hand corner when the camera is set to LIVE and single-
image mode.
By pressing the touch button (g) on the handpiece (or by activating the
foot control), you can freeze the image, which is immediately shown on
the monitor deleting any other previous image.
The last frozen image remains on the monitor even if the camera
is put back in place.
Operation in multiple image mode.
• The "live" image appears on the monitor when the camera is set to LIVE
and multiple image mode.
Pressing the touch button (g) on the handpiece (or activating the foot
control), you can freeze the image, which is immediately shown on the
monitor.
The frozen image appears directly on the monitor in the first box
available on the page currently displayed. Any following frozen
image is then positioned in the following box in reading order.
Once the 4 available boxes have been filled, each following
frozen image will replace the existing ones appearing always in
reading order.
• With the camera in FREEZE mode, by pressing the button (B) or by
activating the CHIP-AIR command using the foot control (see paragraph
5.2), you can select the stored images in rotation.
• With the camera in FREEZE mode, pressing the button (D) you can
enable/disable the full screen display of the selected image.
Press the button (E) for at least 3 seconds to delete all images.
VIEW function.
• With the camera in FREEZE mode, by pressing the touch button (A)
repeatedly, you can scroll down the pages with frozen images.
To Next Page
Loading...
