1 ) Please use FM mode, low power (0.1w-10w) for antenna tuning, and then adjust to normal after tuning
Make contact after checking.
within the holding range.
4 ) During the communication process, please observe the standing wave and power displayed by the radio station at any time, and stop transmitting in time if any abnormal situation occurs.
2 ) Before operation, please confirm whether the operating frequency is within the range of 1.8-30MHz, and the output power of the radio station is adjusted on this day
The device or radio station shall prevail, and refer to Section 3.6 to recalibrate the device.
Power, too high power tuning will cause damage to the radio or tuner.
3 ) If the power and standing wave values displayed by the professional standing wave power meter or the radio station are inconsistent with the values displayed by the tuner, please use a professional
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
http://www.antuner.com
BI3QWQ
1.4 Precautions (important)
Machine Translated by Google
To Next Page
Loading...
