The higher the tuning accuracy is; the larger the value, the faster the tuning speed and the rougher the tuning accuracy.
The default factory parameter of this function is 100%, and the adjustable range is 60%-150%
The default factory parameter of this function is 10, and the adjustable range is 5-50
The default factory parameter of this function is 100W, and the adjustable range is 100W
ÿ
ÿ
10W
The calculation formula is:
This parameter is the sampling value at the lowest starting power, using FT891 to test FM mode, and the value is 55 when transmitting at 5W;
ÿ
Real power value ÷ display value of this day's bar x100= set value
The value is 10 when ICOM705 tests FM mode and 0.1W transmission
ÿ
For example, when the radio is transmitting, the power displayed on the screen of the tuner is 10W, but it is 11W when tested with a professional power meter. Therefore,
ÿ
Please make a reasonable choice according to the maximum power of your radio station, so as to achieve a more accurate power calculation value.
Here the value should be modified to 110%
Generally, when the radio station is listening, the forward voltage and reverse voltage collected by the tuner fluctuate about 1~4, depending on the
The setting of this parameter will not affect or damage the components of the tuner, but only affect the power detection algorithm and related functions in the tuner system
The value will change due to the influence of the antenna feed system. If the setting is too low, the screen of the antenna will enter the tuning state abnormally.
interface max.
ÿ
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
BI3QWQ
http://www.antuner.com
3.5.7 Minimum starting power voltage value ( TUNE MIN ADC )
3.6.1 Setting Radio Power ( FIX RADIO )
3.6 Radio type, power, standing wave calibration
3.6.2 Calibrate the adjustment power value (FIX PWR )
Machine Translated by Google
To Next Page
Loading...
