4. Frequently asked questions
You can modify the parameters related to the sky tune to improve the accuracy.
The displayed value or the value of professional measuring equipment shall prevail.
2) Modify [TUNE MIN ADC] minimum starting power sampling value to "10" or other values.
2) Modify [ USER COUNT ] to be greater than 0 to enable the user storage mode. After the device restarts, it will enter the user storage mode.
1) Modify [TUNE MIN ADC] minimum starting power sampling value to "5" or other values.
1) Modify [FIX RADIO] radio power type to "10W"
ÿ
The tuner itself is limited by the performance and size of components, the displayed power value and standing wave value are for reference only, please use the radio itself to display
1) Modify [FIX RADIO] to the maximum power of your radio, such as 100W or 10W
1) Modify [USER AUTO] to "YES"
The QRP radio may be affected by power amplifier tubes and power supply factors, and the power output is not in a stable state.
1) Modify [TUNE DELAY] The smaller the value, the faster the speed, and the larger the value, the slower the speed.
storage mode interface.
ÿ
ÿ
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
http://www.antuner.com
BI3QWQ
4.1 I am a QRP radio station, what parameters do I need to configure?
4.2 I want to modify the minimum starting power, how to modify?
4.4 I want to increase or decrease the speed of the auto-tuning relay, how to modify it?
4.3 How to set to automatically select the lowest standing wave among the results stored by the user?
4.4 Why are the values displayed by the power meter, standing wave meter and the tuner inconsistent?
Machine Translated by Google
To Next Page
Loading...