ANTUNER AT-100M - Persistent WAIT or TUNE Display; Relay Operation During Tuning

tuning?
4.6 Why does the relay always operate and pause during the tuning process?
4.5 Why the screen always displays "WAIT" or "TUNE" when tuning
BI3QWQ
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
http://www.antuner.com
2) Modify [FIX PWR] to correct by comparing the value of the power meter with the display value of the tuner.
The station turns off VOX or PRC mode;
At this time, it means that the power input detected by the sky tuner is in a non-continuous state. Please follow 4.5 for troubleshooting.
3) Modify [FIX SWR] to correct by comparing the value of the standing wave meter with the value displayed by the tuner.
Whether the station has a good and stable power supply;
Whether the output power of the QRP radio is continuous and stable, you can try to increase the power;
Check whether the antenna feeder system is well grounded, replace the environment or troubleshoot the antenna feeder.
If you press and hold the [button] to enter the manual tuning mode, and the radio station has been in the transmitting state, but it keeps displaying
2) Troubleshooting of Tiantun parameters
"WAIT" or "TUNE", please follow the steps below to troubleshoot.
Enter the tune advanced configuration interface [TUNE MIN ADC] is set too high;
1) Troubleshoot hardware problems
Enter the advanced configuration interface of the tuner [TEST ADC] interface, keep the radio transmitting, and observe whether the value of "FWD" changes
Whether the connection interface between the radio station and the tuner is correct;
change.
Whether the radio mode is FM, whether the power is between (0.1w-10W);
Machine Translated by Google