Note: "ÿ" is a function option that is focused on or frequently used, which will affect the tuning success rate and the minimum standing wave value after tuning.
Recommendation: NO, control
the pull-in state of the relay, close
TUNE MIN ADC 5-50
ÿAutomatic starting wave TUNE AUTOSWR 1.00-2.50
Beep when high
16
voltage failure
60%-150% default 100%
Recommended: 32-40, this value
affects the tuning speed
3
17 Reset the system to restore the default parameters RESET
ring
The number of caches, generally the
Set scope default parameters or functions
ÿSample average times FIX AVG
This will save battery
ÿRadio type FIX RADIO
Stop tuning standing wave TUNE STOPSWR 1.00-2.50 Recommended: 1.10
2 user modes
http://www.antuner.com
function test
1-10
10-80
Recommended: 10, the system
automatically stores the tuning results in
ENTER
13
ÿ
NO/YES
9
set this parameter
6
ÿAutomatic tuning switch TUNE AUTO
Used to troubleshoot signal, battery
pressure, ADC using the test
Corrected standing wave value FIX SWR
1-8
1-20
menu name
ENTER
NO/YES
Default: 100W, according to the
maximum output power of the station
auto tune
Recommendation: YES, when the standing wave
exceeds the threshold, it will automatically adjust
Relay test TEST RELAY
Recommended: 3-6
harmony
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
7
12
ÿMinimum starting power voltage
sampling value
Recommendation: 1.80-2.00 When
the standing wave exceeds this value then
1 Buzzer Buzzer switch BEEP ON
15
barrier
100W/10W
auto tune
0-9
TEST ADC
Correction power value FIX PWR
4
function options
8
ENTER
0.1W), the lower the value, the
lower the starting power
5
Recommended: 0 , user-defined
storage quantity
14 Signal switching signal relay switching switch SWITCH ON
reset
60%-150% default 100%
Recommended: 4, this value has a
great influence on the tuning results
NO/YES
11
Recommended: 5-10 (approximately
number of frequencies used
Default: YES , when the button is
pressed or the standing wave is over
BI3QWQ
Used to troubleshoot relay faults
Tuning delay TUNE DELAY
Storage Quantity USER COUNT
10
Calibration function
ÿTuning step speed TUNE SETP
ÿAutomatic storage quantity TUNE COUNT
No. Main Category
Standing wave, power, battery power
3.2 Menu quick overview
Machine Translated by Google
To Next Page
Loading...
