2.3 Start tuning preparation (important)
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
http://www.antuner.com
BI3QWQ
5) Default mode
1) Launch mode
Although some DIY or QRP radio stations set power greater than 0.1W, the actual output is affected by the performance of the radio's own power amplifier tube
The factory mode of this product is ÿNormal Modeÿ, which is suitable for most users to operate.
Please change the signal mode of the radio station to FM mode, which can ensure that the radio station transmits signals continuously instead of intermittently
It may be lower than 0.1W, which will cause the antenna tuner to fail to detect the signal output. At this time, you can increase the transmission power or adjust the tuner to the lowest
function of this book.
Transmit, the continuously transmitted signal helps the tuner to detect standing waves and automatically control the relay tuning.
For the sampling value of the starting power and voltage, refer to Chapter 3.5.7 of Advanced Operation to modify the value of [TUNE MIN ADC] parameter.
After learning, using, and fully understanding this mode for a period of time, users can try to enable [User Storage Mode] or
If there is no FM mode, try using AM/CW mode in order.
If you use SSB mode, you need to keep talking to the microphone without interrupting the calling, or use your mobile phone to play
Higher-level advanced parameter adjustment, in order to fully customize the various functions of the antenna, to achieve the performance suitable for your own radio station and antenna feeder
parameter.
Recording, just keep the signal output, if the call stops in SSB mode, the tuner will not be able to detect the signal, and the standing wave will not be able to
For details, refer to the [Advanced Operation] chapter.
to tune.
2) Transmission power
In order to protect your radio from being damaged, please make sure the following two parameters are adjusted before using the tuner.
Please adjust the radio power to the lowest value and ÿ 0.1W or ÿ 10W to ensure that the radio will not be damaged by high standing waves.
Machine Translated by Google
To Next Page
Loading...
