EasyManua.ls Logo

ANTUNER AT-100M - Start to Automatically Tune the Standing Wave (TUNE AUTOSWR); Stop Auto-Tuning Standing Wave (TUNE STOPSWR); Relay Delay Time (TUNE DELAY); Relay Combination Step (TUNE STEP)

Default Icon
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When the standing wave exceeds the set [ TUNE AUTOSWR ] value, the program will automatically save the result to the memory, the
The smaller the value, the faster the tuning speed; the larger the value, the slower the tuning speed.
The value is the number of the latest N times of tuning relay combination results that are automatically stored. The larger the value, the more saved, and at the same time
The default factory parameter of this function is 1.10, and the adjustable range is 1.00-2.50
ÿ
It takes longer to tune after changing the frequency.
The default factory parameter of this function is 4, and the adjustable range is 1-8
This value is generally recommended to users according to the number of frequencies that are frequently used automatically, and it can be adjusted in seconds when tuning later.
Currently, this parameter is effective when [ TUNE AUTO ] is YES. During the automatic tuning process, when the standing wave is lower than this value
This parameter is the step-by-step test speed for the relay combination during the automatic tuning process. The smaller the value, the slower the speed.
Tuning will stop automatically.
The default factory parameter of this function is 1.80, and the adjustable range is 1.00-2.50
ÿ
The default factory parameter of this function is 32, and the adjustable range is 10-80
At present, this parameter is effective when [ TUNE AUTO ] is YES. When the standing wave is greater than or equal to this value, the tuner will automatically tune
This parameter is the time for waiting for the relay to complete the action when the relay is turned on and off during the automatic tuning process.
standing wave.
ÿ
ÿ
http://www.antuner.com
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
BI3QWQ
3.5.6 Relay combination stepping (TUNE STEP )
3.5.3 Start to automatically tune the standing wave (TUNE AUTOSWR )
3.5.4 Stop automatic tuning standing wave ( TUNE STOPSWR )
3.5.5 Relay delay time (TUNE DELAY )
Machine Translated by Google

Table of Contents

Other manuals for ANTUNER AT-100M