3.3.1 Buzzer switch ( BEEP ON )
3.4 User storage mode
3.5 Auto-tuning
3.3 Buzzer
3.5.1 Auto-tuning state ( TUNE AUTO )
3.4.1 Number of user storage mode results ( USER COUNT )
3.5.2 Automatic storage quantity ( TUNE COUNT )
ÿ
BI3QWQ
http://www.antuner.com
ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom
take effect.
When this parameter is currently YES, the auto-tuning function is turned on, and all tuning-related parameters in 3.5 TUNE in this chapter are generated.
When the device is far away from the user's operating position or hung on a remote tree, it can be judged whether the current standing wave is
effect.
The default factory parameter of this function is 0, and the adjustable range is 0-9
No more than the threshold [ TUNE AUTOSWR ].
Note: AT-100M version 1 hardware does not support this function.
ÿ
Modifying this parameter can achieve multiple user-defined storage relay combination results, if it is greater than 1, then ÿ USER AUTO ÿ
The default factory parameter of this function is YES, and the adjustable range is NO/YES
ÿ
The default factory parameter of this function is 10, and the adjustable range is 1-20
The default factory parameter of this function is YES, and it will sound when the start button is pressed and the standing wave exceeds the threshold; NO means no sound.
Machine Translated by Google
To Next Page
Loading...