ANTUNER AT-100M - Page 5

36 pages

Save Page as PDF

To Next Page

To Previous Page

ANTUNER only researches ultra-small, portable radio peripherals, and completely develops software and hardware at the bottom

http://www.antuner.com

BI3QWQ

Machine Translated by Google

Main Page

Table of Contents2
To Our Dearest Users6
User Agreement7
Product Introduction8
Appearance Introduction8
Product Performance9
Factory Accessories10
Precautions (Important)11
Quick Start12
How to Connect the Antenna Tuner to the Radio Station and Antenna Feeder12
Precautions for the First Use of the Tuner13
Start Tuning Preparation (Important)14
Auto/Manual Tuning15
Switch between Normal Mode and User Storage Mode18
Introduction to the Function Interface of Normal Mode18
User Storage Mode Function Interface Introduction20
Advanced Operation24
Enter the Advanced Configuration Menu24
Quick Menu List25
Buzzer26
Buzzer Switch ( BEEP on )26
User Storage Mode26
Number of Results in User Storage Mode ( USER COUNT )26
Auto-Tuning26
Auto-Tuning State (TUNE AUTO)26
Automatic Storage Quantity ( TUNE COUNT )26
Start to Automatically Tune the Standing Wave (TUNE AUTOSWR)27
Stop Auto-Tuning Standing Wave (TUNE STOPSWR)27
Relay Delay Time (TUNE DELAY)27
Relay Combination Step (TUNE STEP)27
Minimum Starting Power Voltage Value ( TUNE MIN ADC )28
Radio Type, Power, Standing Wave Calibration28
Set Radio Power ( FIX RADIO )28
Calibrate the Adjustable Power Value (FIX PWR)28
Calibrate the Standing Wave Value (FIX SWR)29
Signal Switching29
Signal Relay Switching Switch (SWITCH ON)29
Function Test30
Relay Function Test ( TEST RELAY )30
Power Sampling Function Test ( TEST ADC )30
Restoring Factory Settings (RESET)31
Frequently Asked Questions32
I am a QRP Radio Station, What Parameters Do I Need to Configure32
I Want to Modify the Minimum Starting Power, How to Modify32
I Want to Increase or Decrease the Speed of the Auto-Tuning Relay, How to Modify It32
How to Set to Automatically Select the Lowest Standing Wave Among the Results Stored by the User32
Why Are the Values Displayed by the Power Meter, Standing Wave Meter and the Tuner Inconsistent32
Why Does the Screen Always Display "WAIT" or "TUNE" When Tuning but Not to Tune33
Why Does the Relay Always Operate and Pause During the Tuning Process33
Why Is the Standing Wave very Low During Low Power Tuning, but Rises after Normal Transmission34
Why Does the Tune Automatically Shut Down, Restart Repeatedly, and the Screen Suddenly Go Black34
Can the Tuner Tune the Standing Wave Greater than 9.9934
Upgrade Log35
V1.22.8C (August 15, 2022)35
V1.22.8A (August 3, 2022)35
V1.22.7C (July 26, 2022)35
V1.22.7B (July 23, 2022)35
V1.22.7A (July 17, 2022, Major Update)35
V1.22.6A (June 7, 2022)36
V1.22.5H (May 29, 2022)36
V1.22.5G (May 19, 2022)36
V1.22.5F (May 10, 2022)36
V1.22.5E (April 30, 2020, Major Upgrade)36
V1.22.5Ad (April 23, 2022)36

ANTUNER AT-100M - Page 5

Table of Contents

Other manuals for ANTUNER AT-100M