WTX Series Owner’s Manual 29
WARNING: DO NOT attempt to perform any disassembly or
service of your BC. Service requiring disassembly must only be
performed by a factory-trained Apeks technician. To
obtain service or repair, such as power inator service or
replacement of the bladder, see your local authorized dealer.
DEALER INSPECTION & SERVICE
1. It cannot be assumed that the BC is in good working order
on the basis that it has received little use since it was last ser-
viced. Remember that prolonged or improper storage can still
result in internal corrosion and/or deterioration of o-ring seals
and valve springs, as well as bladder seam degradation.
2. It is imperative that you obtain prescribed dealer service
for your BC at least once a year from an authorized dealer,
including a general air leak inspection and complete overhaul
of the power inator and OPR valve. Your BC may require this
service more frequently, depending on the amount of use it
receives and the environmental conditions it is used in.
3. If the BC is used for rental or training purposes in salt,
chlorinated, or silted fresh water, it will require prescribed
dealer service every three to six months. Use in chlorinated
water will greatly accelerate the deterioration of most compo-
nents, and require more frequent service.
4. DO NOT attempt to perform any disassembly or overhaul
service of your WTX product. Doing so may cause the BC
to dangerously malfunction, and will render the warranty null
and void. All service must be performed by an authorized
Apeks Dealer.
NOTE: IT IS IMPORTANT TO OBTAIN PRESCRIBED DEALER
SERVICE FOR YOUR WTX SYSTEM AT LEAST ONCE ANNUALLY,
FROM AN AUTHORIZED APEKS DEALER. YOUR PERSONAL
SAFETY AND THE MECHANICAL INTEGRITY OF YOUR WTX
SYSTEM DEPENDS ON IT.
To Next Page
Loading...
Need help?
General
