© Ikonix USA
60
BASE KEYWORD DESCRIPTION VALUE
MEASure :ALL? Query Meter Data
Voltage, Vac voltage, Vdc
voltage, Current, AC current,
DC current, Frequency, Power,
Pfactor, APEAK, Reactive,
Crestfactor, Apparent
:STATe? Query Measurement State
OFF, ON, TRIG TO TEST, Ramp
Up , Ramp Down , OVP_PEAK
, OCP_PEAK , OPP_PEAK ,
OVP , OCP , OPP , FAN_FAIL
, DA_OTP , MCU_FAIL ,
DD_OVP , DD_LVP , DD_OCP
, CALIBRATION_ERROR ,
INT_TEST_FAIL , DD_FAIL ,
RCP_PEAK , RCP , UTPUT_
SHORT , SET_FAIL , AC_OVP
, AC_LVP, PFC_OVP, PFC_LVP,
PFC_OCP, PFC_OTP, DD_OTP,
VSENSE_INT_OVP, VSENSE_
INT_LVP, VSENSE_EXT_OVP,
VSENSE_EXT_LVP, A-Hi, A-Lo,
P-Hi, P-Lo, VA-Hi, VA-Lo, Q-Hi,
PF-Hi, PF-Lo, CF-Hi, CF-Lo, AP-
Hi, AP-Lo
:TIMe[:DWELl]? Query Dwell Time 1.0 – 999.9
:COUNt? Query Count 0 – 50000, 0 = Continous
:SEQuence? Query Sequence Number 0 – 50000, 0 = Continous
:VOLTage?
Query Voltage (AC+DC)
Meter
:VOLTage:AC? Query AC Voltage 0.0 – 310.0 VAC
:VOLTage:DC? Query DC Voltage 0.0 – 420.0 VDC
:FREQuency? Query Frequency 5 – 1200 Hz
:CURRent? Query Current (AC+DC)
:CURRent:AC? Query AC Current *See Specification Table
:CURRent:DC? Query DC Current *See Specification Table
:POWer? Query Power
:PFACtor? Query Power Factor
:APEAK? Query Peak Current
:REACtive Query Reactive Current
:CREStfactor? Query Crest Factor
:APParent Query Apparent Power
7.4.2 Measure Subsystem
To Next Page
Loading...
