2-26
Table 2.4 - GPIB Command Description (continued)
_____________________________________________________________________________
COMMAND RESULT
_____________________________________________________________________________
REC Execute MEMORY RECALL function
RES Returns PMC to RESET state.
SN Sends instrument serial number
SS0
Selects SYNCHROSCOPE output and 0°
SS180
Selects SYNCHROSCOPE output and 180°
STA Selects STANDBY state
STO Execute MEMORY STORE function
V Initializes VOLTAGE Operating mode or displays Voltage if in POWER
or PHASE/POWER FACTOR modes.
W Select POWER Operating Mode
XP Transfers Voltage and Current calibration constants power locations
XV Sends firmware version date (ddmmmyy)
XXXXA Set output to XXXX Amperes
± XXXCO
Adjust calibration constant by + or – XXX hundredths percent
XXXXHZ Set output frequency to XXXXHZ
XXXXMA Set output to XXXX Milliamps (used only on Milliamp ranges, < 100 mA)
± XXXXMV
Set output to + or – XXXX Millivolts (used only on Millivolt range, < 100
mV)
± XXXXPF
Set output to + or – XXXX Power Factor
± XXXXPH
Set output phase to + or – XXXX phase
± XXXXQ
Set output Q to + or – XXXX VARS
± XXXXV
Set output voltage to + or – XXXX Volts
± XXXXW
Set output power to + or – XXXX Watts
X = numerals 0 through 9
An embedded decimal point character may be used as necessary
To Next Page
Loading...
