1-12
Table 1.5 - Supplemental Characteristics
____________________________________________________________________________
TYPE DESCRIPTION
____________________________________________________________________________
Display 20-character alphanumeric vacuum fluorescent display module used
to indicate output and operational status, user prompts, and
diagnostic messages.
Output Mode Selection 4 Keys with LED indicators for selection of RESET, DC, 60HZ, or
400HZ
Function and Display
Selection
6 keys with LED indicators for selection of VOLTAGE,
CURRENT, FREQUENCY, POWER, POWER FACTOR, and
PHASE display and operation.
Display Mode Selection 2 keys with LED indicators for selection of NORMAL or %DEV
display modes.
Value Entry 10 digit keys, a decimal point, and a minus/backspace key for entry
of the desired value for the selected function. If in Operate mode
the output will revert to Standby mode only if the new value is not
within the present output range.
Units Entry 4 units keys: V/A; MV/MA; W/HZ; and DEGREE/ENTER for
selection of correct units following a value entry.
Value Modification A rotary knob, increase and decrease keys allow modification of the
displayed value. Modification extends only to the top and bottom of
the present range.
Rotary Knob Value
Modification
Clockwise rotation increases and counter-clockwise decreases the
displayed value.
To Next Page
Loading...
Need help?
General