Arcam AVR11 User Manual

EN
EN-27
2
Toggles power between standby and on.
1
Open/close disc tray.
0...9
Searches for and plays the track corresponding
to the key pressed.
DISP
Cycles through the front panel
display’s brightness options.
MODE
Cycles through the repeat options (track, disc,
etc.).
7
Fast rewind.
8
Fast forward.
9
Press and release to skip back to the beginning
of the current/previous track
:
Press and release to skip forwards to the
beginning of the next track.
Stop playback of a CD
4;
Pause and playback of the current track.
POP UP
In ‘normal play’ (i.e. the display does not show
the letter P), press the
'
and
,
keys to
select the track and then stores the track.
In ‘program play’ mode, the key deletes
the stored track.
Navigate setup and CD programme selection
menus.
OK selects the highlighted file or enters the
highlighted menu on the screen – equivalent
to ‘Enter’ or ‘Select’ on some remote controls.
'
Up
<
Left
>
Right
,
Down
CD +
'
Power on from Standby
CD +
,
Standby from Power on.
AMP
Resets remote to AMP mode.
RADIO
Plays the programmed tracks.
CD Device Mode
The Device Mode button selects as the source.
The button is configured to control the CD functions of
Arcam CD players, although this can be changed (see
“Locking/Unlocking a specific Device Mode” on page EN-23).

Arcam AVR11 Specifications

General

Type	AV Receiver
Power Output	85W per channel (8 ohms, 2 channels driven)
Total Harmonic Distortion	0.02%
Input Impedance	47k Ohms
HDMI Inputs	7
HDMI Outputs	2
4K (UHD) passthrough	Yes
8K (UHD) passthrough	No
Dolby Atmos	Yes
DTS:X	Yes
IMAX Enhanced	Yes
Dirac Live	Yes
Roon Ready	Yes
Bluetooth	Yes
Wi-Fi	Yes
Ethernet	Yes
Spotify Connect	Yes
USB Port	Yes
Frequency Response	20Hz - 20kHz
Signal-to-Noise Ratio	100dB
AirPlay	Yes
Supported Audio Formats	FLAC, WAV, ALAC, MP3, AAC, WMA
Dimensions	433 x 171 x 425 mm