button for storage and no manual operation for parameter storage and usage.It is easy to use parameter
group. Press the parameter switch button , turn on the parameter group “ ” LED, and switch
parameter groups by encoder “ ” . Select the parameter group and work with the related parameters,
and the group will automatically save the adjusted parameters.
9.2.2 MIG welding mode
1) “Synergic” and “separated”
There are two MIG/MAG welding mode, “synergic” and “separated”, for welding specification
adjustment:
Synergic: Current and voltage settings vary with different welding wire, wire diameter and gas; and
also at the same welding current, wire feed speed and synergic voltage may differ; the welder will
auto-match preset current and welding voltage, and users can adjust the inductance to the standard
position according to the process requirements.
In synergic mode, the welder panel will display preset current on the right LED and preset voltage on
the left LED. The synergic parameter database will auto-match the voltage based on the preset current,
with adjustment range of synergic voltage ±3.0V.
Separated: No relation between wire feed speed and voltage adjustment, and users need to set
values separately.
2) Matching table of relation between welding wire, diameter, shielding gas, material and wire
feeding roll：
In synergic mode, different welding wire, diameter, shielding gas, material and wire feeding roll have
corresponding matching relationship as below table. Please select correct settings to achieve optimal
welding performance.
To Next Page
