23
the unit from moving.
(2) Adopt M12 bolts components to tighten feet and under frame when installing.
(3) Monobloc unit should be installed on concrete base that is 10cm height.
(4) Requirements on installation space dimension of unit’s bodies are shown in following drawing.
(5) Monobloc unit must be lifted by using designated lifting hole. Take care to protect the unit during lift. To
avoid rusting, do not knock the metal parts.
Water connections of monobloc unit
Argoclima recommends to connect water pipes in horizontal direction. Do not connect water pipes in vertical
direction.
Usage of rubber rings
Water return 1” Water supply 1” Grommet
(1) Wires installed by field supply get through the rubber
rings,such as 2-way valve,3-way valve,power cable and
so on.Be careful of separating electrical wire and light
current wire.
(2) Tie the rubber rings after finishing wire connection.
(3) The unit is equipped with a condensation collection
basin, complete with the relevant drain.
Condensation drain
To Next Page
Loading...