To Next PageTo Next Page
Need help?Do you have a question about the Argo AG4HP061PH and is the answer not in the manual?
Guidelines for unit installation according to codes and user involvement.
Procedures and considerations for installing the monobloc unit.
Criteria for choosing a suitable installation site for the monobloc unit.
Technical drawings showing the dimensions and overall size of the monobloc unit.
Recommended clearances around the unit for proper airflow and maintenance access.
Safety measures and procedures to follow during the installation of the monobloc unit.
Instructions and diagrams for correctly connecting water pipes to the monobloc unit.
Guidance on the proper use of rubber rings for cable management and insulation.
Wiring diagrams and instructions for connecting the control panel to the unit's electronics.
Essential safety guidelines and requirements for handling flammable refrigerants during operation.
Graph showing available head pressure vs. water flow rate for the unit's outlet.
Step-by-step instructions and diagrams for wiring the thermostat to the unit.
Overview of 2-way valve types, power, operating modes, and supported functions.
Instructions and diagrams for connecting the 2-way valve wiring.
Details on 3-way valve type, power, operating modes, and supported functions.
Information on connecting the DHW tank temperature sensor.
Procedure for installing the auxiliary heat source in parallel with the main unit.
Instructions for the electrical wiring of the other thermal auxiliary heat source.
Steps for installing the optional electric heater and its associated temperature sensor.
Guide for configuring the wired controller for the optional electric heater.
Methods and procedures for detecting refrigerant leaks in the system.
Guidelines for the physical installation and placement of the insulated water tank.
Specifications for acceptable water quality parameters for the system.
Procedures and principles for electrical wiring.
Recommended specifications for power supply wires and leakage switches.
Diagram and identification of components on the main control board.
General principles for electrical wiring connections within the unit.
Identification and layout of terminal boards for external connections.
Pre-operational checklist and procedures to ensure correct installation before unit startup.
Procedure for testing the unit's operation after installation and commissioning.
Procedures for safely removing and handling refrigerants during servicing or decommissioning.
Steps and precautions for safely decommissioning the unit and recovering refrigerant.
Pre-season checks and recommendations for winter operation and freeze protection.
Procedures for removing exterior panels, grilles, and frames of the unit.
Procedures for removing electric boxes, water system, valves, and lines.
Procedures for removing economizer, compressor, separator, and fan.
Procedures for removing the motor, its support, and separating the condenser.
Procedures for removing electric boxes, heat exchangers, and water system.
Procedure for removing the 4-way valve, including its coil and tubes.
Procedures for removing suction lines, economizer, and associated components.
Steps for removing compressor, separator, and fan.
Procedures for removing motor support and separating the condenser.
General